Readers ask: How To Fix Tpm Malfunction Bmw?

The next step is to reset the TPM warning.

  1. Inflate the tires to the recommended tire pressure.
  2. Press the iDrive knob to select vehicle settings.
  3. Scroll down to Vehicle Tires using the iDrive knob.
  4. Rotate the iDrive knob to select the TPM menu.
  5. Select Reset, then press the iDrive knob.
  6. Select YES.

How do you fix TPMS malfunction?

Drive the car at 50 mph for about 10 minutes. This should reset the sensor, and the next time you start the car the TPMS light should be off. Without starting the car, turn the key to the “On” position. Press the TPMS reset button and hold it until the light blinks three times, then release it.

What is a TPM malfunction on a BMW?

TPM: When a flat tire is detected, the TPMS warning lamps light up yellow and red, a message appears on the iDrive Control Display, and signal sounds. If a system malfunction occurs, the yellow warning light flashes and then lights up continuously. Green: The tire pressure matches the learned set state.

What causes TPM malfunction?

The Leading Cause Of TPMS Failure TPMS module, keyless entry and wiring faults can also prevent a TPMS system from working, but these types of problems are much less common. When a tire pressure sensor fails, the TPMS system should detect the fault and turn on the TPMS warning light or cause the light to flash.

You might be interested:  FAQ: What Is Bmw I3?

How much does it cost to replace TPMS?

In the event pressure sensors need to be replaced, the cost ranges from $50-$250 each depending on vehicle type.

How do you fix a BMW TPM malfunction?

The next step is to reset the TPM warning.

  1. Inflate the tires to the recommended tire pressure.
  2. Press the iDrive knob to select vehicle settings.
  3. Scroll down to Vehicle Tires using the iDrive knob.
  4. Rotate the iDrive knob to select the TPM menu.
  5. Select Reset, then press the iDrive knob.
  6. Select YES.

What is TPMS malfunction?

When your tire pressure monitoring system (TPMS) warning light comes on, flashes repeatedly, and then turns off, this indicates a malfunction with the vehicle’s TPMS system. If the TPMS comes on and stays on, it means your tire has a dangerously low level of air pressure.

Is it safe to drive with TPMS light on?

It’s not safe to drive around with your TPMS light illuminated. Without a tire inspection, there’s no way of knowing how quickly air is leaving your tire, or for how long it has been over or underinflated. The best course of action is to use a tire pressure gauge to check the current inflation level of each tire.

Where is the TPMS reset button?

The TPMS reset button is usually located beneath the steering wheel. If you are unable to find it, refer to your vehicle’s owner’s manual. Inflate all tires to 3 PSI over their recommended amount, then deflate them completely. Be sure to include the spare tire, as it may have a sensor as well.

You might be interested:  Quick Answer: What Is Bmw Connected Package Pro?

How long does it take to reset TPM on BMW?

Just put on tires today and the reset took about 8 minutes of driving and all clear.

Do BMW TPMS need to be programmed?

The TPMS sensors you buy from tire rack will come ready to go. They will not need to be programmed by the dealer.

Leave a Reply

Your email address will not be published. Required fields are marked *